Garage Door Repair in Beaufort, SC
Garage door repair starts with finding the one worn part behind a door that shudders, drags or stops halfway. We price it first and fix only that. Open 24/7.
Exact price on site before any work starts. The diagnostic is $0 with a completed repair.
A sectional garage door is a balanced machine. Springs carry the weight, two cables pass it to the bottom corners, rollers ride the steel tracks, and the opener only supplies the push. When one piece wears, its neighbors take the extra load, so a squeal this week often becomes a snapped part next month.
Our address, 189 Sea Island Parkway, is on Lady's Island, so the islands east of the Woods Bridge are home ground for us rather than a long run out. Salt in the air eats bare steel, and that is why rollers seize, hinges stain with rust and cable strands fray on a coastal door sooner than they would inland.
What a Struggling Door Is Telling You
- It jerks, shudders or climbs crooked: a worn roller, a stretched cable or springs that no longer match.
- It slams shut or will not stay half open: the springs have lost their lift.
- A grind or squeal at the same spot every cycle: a dry roller, a rusted hinge or a bent stretch of track.
- The opener runs but the door barely moves, or it reverses before touching the floor: limit, force or sensor settings, sometimes a door that has drifted out of balance.
- Daylight along the bottom edge or a sagging top section: a worn weather seal, a flexed panel or a loose hinge.
Check the balance, then stop
Close the door, pull the red release cord so the opener lets go, and lift the door by hand to about waist height. A balanced door stays put. If it drops or shoots up, the springs are off. If it is too heavy to lift at all, stop there: a spring has probably broken and the rest of the job belongs to us.
How a Repair Visit Runs
Watch it move
We cycle the door with the opener and then by hand, following the rollers, hinges and cables and listening for where the noise starts.
Name the part
You hear which part has worn and why, and you get the exact figure on site before a tool comes out.
Replace what failed
The worn part comes off, the moving points get a garage-door lubricant, and the hardware that vibrates loose gets re-torqued.
Prove it works
The door runs a full opener cycle, a hand-balance check and the reverse-on-contact test before we pack up.
Starting Prices — Garage Door Repair
- Garage Door Spring Replacement per spring
- From $150
- Garage Door Cable Replacement per cable
- From $150
- Roller Replacement per set
- From $120
- Track Repair & Off-Track Door per door
- From $150
- Diagnostic Service Call $0 when a repair is completed
- $0
Starting prices apply to the part itself. Door weight, size and hardware grade set the final figure, and you hear it on site before we begin.